Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The lid keeps the sand soft between sessions; the side garage holds moulds and tools. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in white; each bay's name is in the matching colour. Prints as shown on its floor, no supports.
Slots take standard 7.5 cm square tiles on edge; the side bin takes triangles. Prints as shown on its floor, no supports.
Print the lid in a speckled filament for a real egg look. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Hang at child height through the keyholes; darts stand nose-up in the rows. Prints as shown on its floor, no supports.
Read the notes together later, then tell your child the monster ate them. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Keep the lid on between sessions so the slime doesn't dry out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Run the seat's lap strap or a buckle strap through the side slots. Prints as shown on its floor, no supports.
Print upright; drop a bag of sand into the base for weight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.