Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Keep garlic and dried herbs together
A round jar with a press-on lid and ring pull to keep garlic and dried herbs together.
Printing notes
97.8 cm³
Volume
121.3 g
Est. weight
1,848
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
MAIN PURPOSE: Dry sponges and scrubbers by the sink
A small tray with a honeycomb floor so sponges and scrubbers dry quickly by the sink.
Printing notes
10.6 cm³
Volume
13.1 g
Est. weight
4,032
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store pot lids and boards on edge
Four upright slots that keep pot lids, baking trays and boards on their edge.
Printing notes
115.5 cm³
Volume
143.2 g
Est. weight
144
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep takeaway sauce sachets within reach
A grab-and-go bin for takeaway sauce sachets, with a label slot and a front finger notch.
Printing notes
30.7 cm³
Volume
38.1 g
Est. weight
256
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a dozen eggs in the fridge
Twelve cups that keep eggs safe in the fridge, with notches front and back to carry it.
Printing notes
91.8 cm³
Volume
113.9 g
Est. weight
312
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep snacks visible in the fridge
A wide bin with a low front so snacks are easy to see and grab from the fridge.
Printing notes
76.5 cm³
Volume
94.9 g
Est. weight
5,572
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Organise measuring spoons and scoops
A long rounded tray with four sections for measuring spoons and scoops.
Printing notes
37.4 cm³
Volume
46.3 g
Est. weight
1,028
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep chopsticks and reusable straws tidy
A long box with two lanes for chopsticks and reusable straws, with a lift-off lid.
Printing notes
171.7 cm³
Volume
212.9 g
Est. weight
176
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Store pantry food in a labelled bin
A deep pantry bin with a label slot, a front finger notch and PANTRY on the back.
Printing notes
59.4 cm³
Volume
73.6 g
Est. weight
1,576
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold piping tips, scrapers and brushes
A hexagon holder with six sections for piping tips, scrapers and pastry brushes.
Printing notes
148.0 cm³
Volume
183.6 g
Est. weight
140
Triangles
Prints as shown on its floor, no supports.