Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold sticky notes ready to grab
A square box for 76 mm sticky notes, with finger notches front and back.
Printing notes
15.2 cm³
Volume
18.9 g
Est. weight
260
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store rubber stamps and ink pads
A box with a press-on lid and ring pull for stamps and ink pads.
Printing notes
131.8 cm³
Volume
163.4 g
Est. weight
2,008
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
MAIN PURPOSE: Store USB sticks and memory cards
Six slots for USB sticks and memory cards, with a lift-off lid.
Printing notes
66.2 cm³
Volume
82.0 g
Est. weight
308
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hold whiteboard markers and erasers
A long tray for whiteboard markers and erasers that hangs on three screws.
Printing notes
26.4 cm³
Volume
32.7 g
Est. weight
864
Triangles
Prints as shown on its floor, no supports.