Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports: three trays, two columns and the pedestal. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports: three trays, two columns and the pedestal. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in yellow PETG for the cheese board. Prints as shown on its outline, no supports.