Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG or TPU so the clip flexes. Prints flat as a plate, no supports.
Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print several in PETG or ASA. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print three, in PETG or ASA for outdoor pots. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Flip it so the pegs point down into the tray. Prints flat as a plate, no supports.