Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print three or four. 16 mm glass marbles. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print as it comes (profile on the bed); the ribbon is solid.
PETG, 4 perimeters for watertight walls. Prints as shown on its floor, no supports.
PLA, 1 mm; an M4 nut glued in the pocket. Prints flat as a plate, no supports.
Print upright; PVA or hot glue for the finds. Prints as shown on its floor, no supports.
PETG for springy legs. A 10 mm coin motor and CR2032 cell. Prints as shown on its outline, no supports.
Prints flat as a plate, no supports.
Print twenty or more. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 50 cm of cord and a table-tennis ball. Prints as shown on its floor, no supports. Stacked parts are fused into one print.