Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the diameter or the curve in the editor, or add a wall pattern, to make your own.
Silk or gradient PLA makes the plain curve glow. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the curve in the editor, or add a wall pattern, to make your own.
Silk, marble or matte PLA all look good on the smooth surface; it prints quickly and uses little filament. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Translucent or silk PLA shows off the reeds. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the reed depth in the editor to make your own.
Translucent PETG gives a ribbed-glass look and holds water for fresh flowers; in PLA, stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the reed depth in the editor to make your own.
Translucent or glossy PLA makes it look like reeded glass; 3 walls keep the reeds solid. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Silk or marble PLA shows off the flutes. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the flute depth in the editor to make your own.
Use 3 walls so the flutes print solid. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the flute depth in the editor to make your own.
Marble or stone-effect PLA gives it a classical look; 3 walls keep the flutes solid. Prints as shown on its floor, no supports.