Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Print flat; check the bearing fit on the centre hole first and scale slightly if it is too tight.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print stake-down in PETG; the cup prints on top without supports. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Print flange-down; no supports. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print floor-down as shown, then turn it over to use it.