Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size or the flute depth in the editor to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Silk or marble PLA shows off the flutes. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the flute depth in the editor to make your own.
Use 3 walls so the flutes print solid. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the flute depth in the editor to make your own.
Marble or stone-effect PLA gives it a classical look; 3 walls keep the flutes solid. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. Matte terracotta PLA gives a pottery look. Prints as shown on its floor, no supports.
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size or the ring spacing in the editor to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Matte terracotta or stone-effect PLA makes it look like real pottery. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the ring spacing in the editor to make your own.
Matte or stone-effect PLA gives a ceramic look. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the curve or the ring spacing in the editor to make your own.
Matte or stone-effect PLA gives it a turned-ceramic look; 3 walls keep the rings solid. Prints as shown on its floor, no supports.