Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. Matte terracotta PLA gives a pottery look. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Matte terracotta or stone-effect PLA makes it look like real pottery. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the curve or the ring spacing in the editor to make your own.
Matte or stone-effect PLA gives it a turned-ceramic look; 3 walls keep the rings solid. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Silk or dual-colour PLA makes the spiral stand out. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the flute depth or the twist in the editor to make your own.
Silk PLA makes the rounded flutes shimmer as they turn; 3 walls keep the flutes solid. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. Wood-fill PLA gives a natural wicker look. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Wood-fill or matte tan PLA makes the weave look like real rattan. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the curve or the weave size in the editor to make your own.
Wood-fill or matte tan PLA makes it look like real woven rattan. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.