Icing Corner

Hold gingerbread walls square while icing sets

Gingerbread walls never stand up while the icing sets. Put one corner inside each corner of the house, press the two iced walls against its outer faces and they stay square and upright for the twenty minutes the royal icing needs. Print four, one per corner, and lift them out before the roof goes on.

Customize this model

Size: 90 × 90 × 80 mm
Shape: Rectangular
Walls: 3.0 mm
Volume: 26.4 cm³
Est. weight (PLA): 32.7 g
Parts to print: 1
Category: Baking & sweets
Made by: Krypto
Built in: 9 steps

What’s in it

Rectangular, 90 × 90 × 80 mm, with 3.0 mm walls

How to print it

Food-safe PETG; print four.

Prints as shown on its floor, no supports.

Filament: at most about 32.7 g of PLA printed solid (roughly $0.65 at $20 per kg); normal infill uses less.

To get the files, open it in the generator and choose File › Download STL (one file per part) or Download 3MF (every part on one plate).

Questions

What size is the icing Corner model?

The icing Corner model measures 90 × 90 × 80 mm (width × depth × height). You can change every size in the free SO3D.xyz generator before you download it.

Does it need supports?

No. Food-safe PETG; print four. Prints as shown on its floor, no supports.

How much filament does it use?

At most about 32.7 g of PLA (26.4 cm³ printed solid), roughly $0.65 of filament at $20 per kg. Normal infill uses less.

Can I change it?

Yes. Open it in the SO3D.xyz generator (free, in your browser), change the size, walls, dividers, holes, text or anything else, then download it as STL or 3MF for your slicer.